# i3status configuration file. # see "man i3status" for documentation. # It is important that this file is edited as UTF-8. # The following line should contain a sharp s: # ß # If the above line is not correctly displayed, fix your editor first! general { colors = true interval = 2 color_good = "#8bc34a" color_degraded = "#eceff1" color_bad = "#ff9800" } # order += "ipv6" order += "disk /" order += "run_watch DHCP" order += "run_watch VPN" order += "wireless wlan0" order += "ethernet eth0" order += "battery 0" order += "load" order += "volume master" order += "tztime local" wireless wlan0 { format_up = " %quality at %essid) %ip" format_down = " down" } ethernet eth0 { # if you use %speed, i3status requires root privileges format_up = "E: %ip (%speed)" format_down = "E: down" } battery 0 { format = " %percentage %remaining" } run_watch DHCP { pidfile = "/var/run/dhclient*.pid" } run_watch VPN { pidfile = "/var/run/vpnc/pid" } tztime local { format = "%d.%m.%Y %H:%M:%S" } volume master { format = " %volume" device = "default" mixer = "Master" mixer_idx = 0 } load { format = "%1min" } disk "/" { format = " %percentage_avail avail - %avail" }