From 7d50ad444ffadd4110152113cc9583db96b3ad67 Mon Sep 17 00:00:00 2001 From: David Lamparter Date: Sat, 3 Nov 2012 11:19:52 -0700 Subject: doc: update installation instructions configure parameters have changed quite a bit, several options are enabled by default now and there's --disable-tests. Update documentation to match. Signed-off-by: David Lamparter --- doc/install.texi | 18 ++++++++++++------ 1 file changed, 12 insertions(+), 6 deletions(-) (limited to 'doc') diff --git a/doc/install.texi b/doc/install.texi index 16e29c99..1cc65574 100644 --- a/doc/install.texi +++ b/doc/install.texi @@ -79,21 +79,27 @@ file does not match to the current running kernel, configure script will not turn on netlink support. @item --enable-snmp Enable SNMP support. By default, SNMP support is disabled. -@item --enable-opaque-lsa -Enable support for Opaque LSAs (RFC2370) in ospfd. +@item --disable-opaque-lsa +Disable support for Opaque LSAs (RFC2370) in ospfd. @item --disable-ospfapi Disable support for OSPF-API, an API to interface directly with ospfd. OSPF-API is enabled if --enable-opaque-lsa is set. @item --disable-ospfclient Disable building of the example OSPF-API client. -@item --enable-ospf-te -Enable support for OSPF Traffic Engineering Extension (internet-draft) this +@item --disable-ospf-te +Disable support for OSPF Traffic Engineering Extension (internet-draft) this requires support for Opaque LSAs. @item --enable-multipath=@var{ARG} Enable support for Equal Cost Multipath. @var{ARG} is the maximum number of ECMP paths to allow, set to 0 to allow unlimited number of paths. -@item --enable-rtadv -Enable support IPV6 router advertisement in zebra. +@item --disable-rtadv +Disable support IPV6 router advertisement in zebra. +@item --disable-tests +Do not build tests. Test programs are built by default, but not ran or +installed. They can be excluded from build with this option, which will +minimally decrease compile time and overhead. They can always be built and +executed at a later time by running @command{make check} in the @file{tests/} +subdirectory, even if they're excluded from build. @end table You may specify any combination of the above options to the configure -- cgit v1.2.1