diff options
Diffstat (limited to 'README')
| -rw-r--r-- | README | 8 |
1 files changed, 6 insertions, 2 deletions
@@ -40,8 +40,8 @@ Software installation 1. Install the required packages (gcc-avr, avr-libc, etc.)
sudo apt-get install arduino-core
-2. Get the arduino software version 0018 (0023 works for RAMPS), uncompress it in a directory
-Arduino software v1 DOES NOT work with Sprinter yet!
+2. Get the arduino software version 0018 (0023 works for RAMPS), uncompress it in a directory.
+Arduino software v1 has not been tested much, but is known to work with some boards.
http://www.arduino.cc/en/Main/Software
3. Get the sanguino software, version 0018
@@ -95,6 +95,10 @@ also for the mentioned hardware setup 13. Click on "the arrow going to the right" button to upload (you had done steps 7,8,9 before, right ?).
If everything goes well you should see the message "Done uploading".
+if GEN7 with 20 Mhz is in use set the Fuses for Bootloader to
+lfuse= 0xF7 hfuse = 0xD4 efuse = FD
+Brownout must be 2,7 V
+
Congratulations, you have just upgraded the firmware of your RepRap !
You can use pronterface.py to do some manual verifications by moving the printer's tip along
|