diff options
Diffstat (limited to 'Sprinter')
| -rw-r--r-- | Sprinter/Configuration.h | 5 | ||||
| -rw-r--r-- | Sprinter/Sprinter.pde | 33 |
2 files changed, 20 insertions, 18 deletions
diff --git a/Sprinter/Configuration.h b/Sprinter/Configuration.h index d8bc8ea..354e59d 100644 --- a/Sprinter/Configuration.h +++ b/Sprinter/Configuration.h @@ -145,8 +145,9 @@ char uuid[] = "00000000-0000-0000-0000-000000000000"; // If the temperature has not increased at the end of that period, the target temperature is set to zero. It can be reset with another M104/M109 //#define WATCHPERIOD 5000 //5 seconds -// Wait this long after achieving target temperature on M109 before continuing with print (seconds) -//#define TEMP_RESIDENCY_TIME 20 +// Actual temperature must be close to target for this long before M109 returns success +//#define TEMP_RESIDENCY_TIME 20 // (seconds) +//#define TEMP_HYSTERESIS 5 // (C°) range of +/- temperatures considered "close" to the target one //// The minimal temperature defines the temperature below which the heater will not be enabled #define MINTEMP 5 diff --git a/Sprinter/Sprinter.pde b/Sprinter/Sprinter.pde index 10e0648..c6932cf 100644 --- a/Sprinter/Sprinter.pde +++ b/Sprinter/Sprinter.pde @@ -772,7 +772,16 @@ inline void process_commands() } #endif codenum = millis(); - while(current_raw < target_raw) { + #ifdef TEMP_RESIDENCY_TIME + long residencyStart; + residencyStart = -1; + /* continue to loop until we have reached the target temp + _and_ until TEMP_RESIDENCY_TIME hasn't passed since we reached it */ + while( current_raw < target_raw + || (residencyStart > -1 && (millis() - residencyStart) < TEMP_RESIDENCY_TIME*1000) ) { + #else + while(current_raw < target_raw) { + #endif if( (millis() - codenum) > 1000 ) //Print Temp Reading every 1 second while heating up. { Serial.print("T:"); @@ -780,23 +789,15 @@ inline void process_commands() codenum = millis(); } manage_heater(); - } - // wait extra time before letting the print continue - #ifdef TEMP_RESIDENCY_TIME - { - long residencyStart = millis(); - codenum = millis(); - while(millis()-residencyStart<(TEMP_RESIDENCY_TIME*1000)) { - if( (millis() - codenum) > 1000 ) //Print Temp Reading every 1 second while heating up. - { - Serial.print("T:"); - Serial.println( analog2temp(current_raw) ); - codenum = millis(); + #ifdef TEMP_RESIDENCY_TIME + /* start/restart the TEMP_RESIDENCY_TIME timer whenever we reach target temp for the first time + or when current temp falls outside the hysteresis after target temp was reached */ + if ( (residencyStart == -1 && current_raw >= target_raw) + || (residencyStart > -1 && labs(analog2temp(current_raw) - analog2temp(target_raw)) > TEMP_HYSTERESIS) ) { + residencyStart = millis(); } - manage_heater(); - } + #endif } - #endif break; case 190: // M190 - Wait bed for heater to reach target. |