diff options
Diffstat (limited to 'Tonokip_Firmware')
| -rw-r--r-- | Tonokip_Firmware/configuration.h | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/Tonokip_Firmware/configuration.h b/Tonokip_Firmware/configuration.h index 2643338..f2d23f0 100644 --- a/Tonokip_Firmware/configuration.h +++ b/Tonokip_Firmware/configuration.h @@ -27,8 +27,8 @@ //Acceleration settings #ifdef RAMP_ACCELERATION //X, Y, Z, E maximum start speed for accelerated moves. E default values are good for skeinforge 40+, for older versions raise them a lot. -float max_start_speed_units_per_second[] = {35.0,35.0,0.2,10.0}; -long max_acceleration_units_per_sq_second[] = {750,750,50,4000}; // X, Y, Z and E max acceleration in mm/s^2 for printing moves or retracts +float max_start_speed_units_per_second[] = {25.0,25.0,0.2,10.0}; +long max_acceleration_units_per_sq_second[] = {3000,3000,50,10000}; // X, Y, Z and E max acceleration in mm/s^2 for printing moves or retracts long max_travel_acceleration_units_per_sq_second[] = {1500,1500,50}; // X, Y, Z max acceleration in mm/s^2 for travel moves #endif #ifdef EXP_ACCELERATION @@ -54,10 +54,10 @@ float min_constant_speed_units = 2; // the minimum units of an accelerated move #endif //How often should the heater check for new temp readings, in milliseconds -#define HEATER_CHECK_INTERVAL 50 +#define HEATER_CHECK_INTERVAL 500 #define BED_CHECK_INTERVAL 5000 -//Uncomment the following line to disable heat management during acceleration -//#define DISABLE_CHECK_DURING_ACC +//Comment the following line to enable heat management during acceleration +#define DISABLE_CHECK_DURING_ACC #ifndef DISABLE_CHECK_DURING_ACC //Uncomment the following line to disable heat management during the move //#define DISABLE_CHECK_DURING_MOVE |