diff options
Diffstat (limited to 'Tonokip_Firmware')
| -rw-r--r-- | Tonokip_Firmware/Tonokip_Firmware.pde | 21 |
1 files changed, 18 insertions, 3 deletions
diff --git a/Tonokip_Firmware/Tonokip_Firmware.pde b/Tonokip_Firmware/Tonokip_Firmware.pde index 26b6af7..15014fc 100644 --- a/Tonokip_Firmware/Tonokip_Firmware.pde +++ b/Tonokip_Firmware/Tonokip_Firmware.pde @@ -54,11 +54,11 @@ void kill(byte debug); // G92 - Set current position to cordinates given //RepRap M Codes -// M104 - Set target temp +// M104 - Set extruder target temp // M105 - Read current temp // M106 - Fan on // M107 - Fan off -// M109 - Wait for current temp to reach target temp. +// M109 - Wait for extruder current temp to reach target temp. // M114 - Display current position //Custom M Codes @@ -81,6 +81,8 @@ void kill(byte debug); // M86 - If Endstop is Not Activated then Abort Print. Specify X and/or Y // M92 - Set axis_steps_per_unit - same syntax as G92 // M115 - Capabilities string +// M140 - Set bed target temp +// M190 - Wait for bed current temp to reach target temp. @@ -698,7 +700,7 @@ inline void process_commands() #endif return; //break; - case 109: // M109 - Wait for heater to reach target. + case 109: // M109 - Wait for extruder heater to reach target. if (code_seen('S')) target_raw = temp2analog(code_value()); #ifdef WATCHPERIOD if(target_raw>current_raw){ @@ -719,6 +721,19 @@ inline void process_commands() manage_heater(); } break; + case 190: // M190 - Wait bed for heater to reach target. + if (code_seen('S')) target_bed_raw = temp2analog(code_value()); + previous_millis_heater = millis(); + while(current_bed_raw < target_bed_raw) { + if( (millis()-previous_millis_heater) > 1000 ) //Print Temp Reading every 1 second while heating up. + { + Serial.print("B:"); + Serial.println( analog2temp(current_bed_raw) ); + previous_millis_heater = millis(); + } + manage_heater(); + } + break; case 106: //M106 Fan On if (code_seen('S')){ digitalWrite(FAN_PIN, HIGH); |