sprinter - Firmware for 3d printer

Age	Commit message (Collapse)	Author
2012-07-18	Version 1.3.21T	midopple
	- M301 set PID Parameter, After PID values change use M500 to store to EEPROM - If no PID is used, deaktivate Variables for PID settings
2012-06-27	calculate eeprom parameter addresses based on previous param address plus ↵	Felipe Corrêa da Silva Sanches
	sizeof(type)
2012-06-27	refactor eeprom routines to make it possible to modify the value of a single ↵	Felipe Corrêa da Silva Sanches
	parameter
2012-06-12	Version 1.3.19T	midopple
	- Set maximum acceleration. If "steps per unit" is Change the acc were not recalculatet - Extra Parameter for Max Extruder Jerk - New Parameter (max_e_jerk) in EEPROM --> Default settings after update !!
2012-02-17	The microcontroller can store settings to EEPROM	midopple
	to use the fuction set in configuration.h #define USE_EEPROM_SETTINGS --> Save and recall Settings aktive #define PRINT_EEPROM_SETTING --> Print settings to UART Commands: M500 - stores paramters in EEPROM M501 - reads parameters from EEPROM M502 - reverts to the default M503 - Print Settings