| Age | Commit message (Collapse) | Author | |
|---|---|---|---|
| 2012-06-27 | calculate eeprom parameter addresses based on previous param address plus ↵ | Felipe Corrêa da Silva Sanches | |
| sizeof(type) | |||
| 2012-06-27 | refactor eeprom routines to make it possible to modify the value of a single ↵ | Felipe Corrêa da Silva Sanches | |
| parameter | |||
| 2012-06-12 | Version 1.3.19T | midopple | |
| - Set maximum acceleration. If "steps per unit" is Change the acc were not recalculatet - Extra Parameter for Max Extruder Jerk - New Parameter (max_e_jerk) in EEPROM --> Default settings after update !! | |||
| 2012-02-17 | The microcontroller can store settings to EEPROM | midopple | |
| to use the fuction set in configuration.h #define USE_EEPROM_SETTINGS --> Save and recall Settings aktive #define PRINT_EEPROM_SETTING --> Print settings to UART Commands: M500 - stores paramters in EEPROM M501 - reads parameters from EEPROM M502 - reverts to the default M503 - Print Settings | |||
 |
index : sprinter | |
| Firmware for 3d printer | sublab |
| summaryrefslogtreecommitdiff |