diff options
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/quagga.info | 341 |
1 files changed, 173 insertions, 168 deletions
diff --git a/doc/quagga.info b/doc/quagga.info index 5fa72ae2..8e3c9262 100644 --- a/doc/quagga.info +++ b/doc/quagga.info @@ -1,5 +1,4 @@ -This is ../../../doc/quagga.info, produced by makeinfo version 4.8 from -../../../doc/quagga.texi. +This is quagga.info, produced by makeinfo version 4.8 from quagga.texi. Copyright (C) 1999-2005 Kunihiro Ishiguro, et al. @@ -25,8 +24,8 @@ END-INFO-DIR-ENTRY This file documents the Quagga Software Routing Suite which manages common TCP/IP routing protocols. - This is Edition 0.99.1, last updated 10 September 2005 of `The -Quagga Manual', for Quagga Version 0.99.1. + This is Edition 0.99.1, last updated 11 October 2005 of `The Quagga +Manual', for Quagga Version 0.99.1. Copyright (C) 1999-2005 Kunihiro Ishiguro, et al. @@ -4304,11 +4303,17 @@ fig:normal-processing::, it consists of three steps: its attributes modified. Those routes which are accepted by the `Out' filters of a peer are announced to that peer. - Figure 10.1: Announcement processing inside a "normal" BGP speaker + - Figure 10.2: Full Mesh +Figure 10.1: Announcement processing inside a "normal" BGP speaker - Figure 10.3: Route Server and clients + + +Figure 10.2: Full Mesh + + + +Figure 10.3: Route Server and clients Of course we want that the routing tables obtained in each of the routers are the same when using the route server than when not. But as @@ -6891,166 +6896,166 @@ VTY Key Index Tag Table: -Node: Top1971 -Node: Overview3329 -Node: About Quagga4730 -Node: System Architecture6983 -Node: Supported Platforms9673 -Node: Supported RFC10814 -Node: How to get Quagga12896 -Node: Mailing List13650 -Node: Bug Reports14097 -Node: Installation14975 -Node: Configure the Software15409 -Node: The Configure script and its options15657 -Node: Least-Privilege support18845 -Node: Linux notes20581 -Ref: Linux notes-Footnote-122439 -Node: Build the Software22505 -Node: Install the Software23053 -Node: Basic commands24513 -Node: Config Commands25288 -Node: Basic Config Commands26181 -Node: Sample Config File31671 -Node: Terminal Mode Commands32441 -Node: Common Invocation Options33538 -Node: Virtual Terminal Interfaces34945 -Node: VTY Overview35456 -Node: VTY Modes36707 -Node: VTY View Mode37157 -Node: VTY Enable Mode37407 -Node: VTY Other Modes37685 -Node: VTY CLI Commands37861 -Node: CLI Movement Commands38321 -Node: CLI Editing Commands38844 -Node: CLI Advanced Commands39432 -Node: Zebra40198 -Node: Invoking zebra40707 -Node: Interface Commands41286 -Node: Static Route Commands42818 -Node: zebra Terminal Mode Commands46091 -Node: RIP47056 -Node: Starting and Stopping ripd47993 -Node: RIP netmask49406 -Node: RIP Configuration50505 -Node: How to Announce RIP route54770 -Node: Filtering RIP Routes57333 -Node: RIP Metric Manipulation58800 -Node: RIP distance59713 -Node: RIP route-map60528 -Node: RIP Authentication63044 -Node: RIP Timers64151 -Node: Show RIP Information65437 -Node: RIP Debug Commands66810 -Node: RIPng67806 -Node: Invoking ripngd68126 -Node: ripngd Configuration68375 -Node: ripngd Terminal Mode Commands69126 -Node: ripngd Filtering Commands69490 -Node: OSPFv269999 -Node: Configuring ospfd70651 -Node: OSPF router71199 -Node: OSPF area79525 -Node: OSPF interface85650 -Ref: ip ospf dead-interval minimal87219 -Node: Redistribute routes to OSPF89791 -Node: Showing OSPF information92449 -Ref: show ip ospf92634 -Node: Debugging OSPF93965 -Node: OSPF Configuration Examples95040 -Node: OSPFv396410 -Node: OSPF6 router96763 -Node: OSPF6 area97117 -Node: OSPF6 interface97295 -Node: Redistribute routes to OSPF698172 -Node: Showing OSPF6 information98488 -Node: OSPF6 Configuration Examples99345 -Node: BGP99766 -Node: Starting BGP100688 -Node: BGP router101265 -Node: BGP distance102509 -Node: BGP decision process102947 -Node: BGP network103429 -Node: BGP route103619 -Node: Route Aggregation104175 -Node: Redistribute to BGP104744 -Node: BGP Peer105271 -Node: Defining Peer105458 -Node: BGP Peer commands106071 -Node: Peer filtering108475 -Node: BGP Peer Group108983 -Node: BGP Address Family109296 -Node: Autonomous System109450 -Node: AS Path Regular Expression110327 -Node: Display BGP Routes by AS Path111574 -Node: AS Path Access List112014 -Node: Using AS Path in Route Map112481 -Node: Private AS Numbers112762 -Node: BGP Communities Attribute112920 -Node: BGP Community Lists115381 -Node: Numbered BGP Community Lists118035 -Node: BGP Community in Route Map119622 -Node: Display BGP Routes by Community121565 -Node: Using BGP Communities Attribute122734 -Node: BGP Extended Communities Attribute126302 -Node: BGP Extended Community Lists128074 -Node: BGP Extended Communities in Route Map129949 -Node: Displaying BGP routes130408 -Node: Show IP BGP130645 -Node: More Show IP BGP131345 -Node: Capability Negotiation132496 -Node: Route Reflector135968 -Node: Route Server136247 -Node: Multiple instance137313 -Node: BGP instance and view139158 -Node: Routing policy140538 -Node: Viewing the view141306 -Node: How to set up a 6-Bone connection141591 -Node: Dump BGP packets and table142963 -Node: BGP Configuration Examples143545 -Node: Configuring Quagga as a Route Server152496 -Node: Description of the Route Server model153457 -Ref: fig:normal-processing155034 -Ref: fig:full-mesh155103 -Ref: fig:route-server155128 -Ref: filter-delegation155470 -Ref: Route Server tasks156654 -Ref: Route-server path filter process157025 -Ref: fig:rs-processing159339 -Node: Commands for configuring a Route Server159492 -Node: Example of Route Server Configuration162519 -Node: Configuration of the BGP routers without Route Server163440 -Node: Configuration of the BGP routers with Route Server166323 -Node: Configuration of the Route Server itself167624 -Node: Further considerations about Import and Export route-maps172623 -Node: VTY shell175667 -Node: VTY shell username176336 -Node: VTY shell integrated configuration176968 -Node: Filtering178416 -Node: IP Access List178769 -Node: IP Prefix List179155 -Node: ip prefix-list description182174 -Node: ip prefix-list sequential number control182701 -Node: Showing ip prefix-list183243 -Node: Clear counter of ip prefix-list184351 -Node: Route Map184790 -Node: Route Map Command188235 -Node: Route Map Match Command188544 -Node: Route Map Set Command189168 -Node: Route Map Call Command190076 -Node: Route Map Exit Action Command190406 -Node: Route Map Examples190888 -Node: IPv6 Support191400 -Node: Router Advertisement191972 -Node: Kernel Interface197588 -Node: SNMP Support199545 -Node: Getting and installing an SNMP agent200144 -Node: SMUX configuration200717 -Node: MIB and command reference202853 -Node: Handling SNMP Traps204268 -Node: Zebra Protocol210347 -Node: Packet Binary Dump Format212261 -Node: Command Index223871 -Node: VTY Key Index282532 +Node: Top1943 +Node: Overview3301 +Node: About Quagga4702 +Node: System Architecture6955 +Node: Supported Platforms9645 +Node: Supported RFC10786 +Node: How to get Quagga12868 +Node: Mailing List13622 +Node: Bug Reports14069 +Node: Installation14947 +Node: Configure the Software15381 +Node: The Configure script and its options15629 +Node: Least-Privilege support18817 +Node: Linux notes20553 +Ref: Linux notes-Footnote-122411 +Node: Build the Software22477 +Node: Install the Software23025 +Node: Basic commands24485 +Node: Config Commands25260 +Node: Basic Config Commands26153 +Node: Sample Config File31643 +Node: Terminal Mode Commands32413 +Node: Common Invocation Options33510 +Node: Virtual Terminal Interfaces34917 +Node: VTY Overview35428 +Node: VTY Modes36679 +Node: VTY View Mode37129 +Node: VTY Enable Mode37379 +Node: VTY Other Modes37657 +Node: VTY CLI Commands37833 +Node: CLI Movement Commands38293 +Node: CLI Editing Commands38816 +Node: CLI Advanced Commands39404 +Node: Zebra40170 +Node: Invoking zebra40679 +Node: Interface Commands41258 +Node: Static Route Commands42790 +Node: zebra Terminal Mode Commands46063 +Node: RIP47028 +Node: Starting and Stopping ripd47965 +Node: RIP netmask49378 +Node: RIP Configuration50477 +Node: How to Announce RIP route54742 +Node: Filtering RIP Routes57305 +Node: RIP Metric Manipulation58772 +Node: RIP distance59685 +Node: RIP route-map60500 +Node: RIP Authentication63016 +Node: RIP Timers64123 +Node: Show RIP Information65409 +Node: RIP Debug Commands66782 +Node: RIPng67778 +Node: Invoking ripngd68098 +Node: ripngd Configuration68347 +Node: ripngd Terminal Mode Commands69098 +Node: ripngd Filtering Commands69462 +Node: OSPFv269971 +Node: Configuring ospfd70623 +Node: OSPF router71171 +Node: OSPF area79497 +Node: OSPF interface85622 +Ref: ip ospf dead-interval minimal87191 +Node: Redistribute routes to OSPF89763 +Node: Showing OSPF information92421 +Ref: show ip ospf92606 +Node: Debugging OSPF93937 +Node: OSPF Configuration Examples95012 +Node: OSPFv396382 +Node: OSPF6 router96735 +Node: OSPF6 area97089 +Node: OSPF6 interface97267 +Node: Redistribute routes to OSPF698144 +Node: Showing OSPF6 information98460 +Node: OSPF6 Configuration Examples99317 +Node: BGP99738 +Node: Starting BGP100660 +Node: BGP router101237 +Node: BGP distance102481 +Node: BGP decision process102919 +Node: BGP network103401 +Node: BGP route103591 +Node: Route Aggregation104147 +Node: Redistribute to BGP104716 +Node: BGP Peer105243 +Node: Defining Peer105430 +Node: BGP Peer commands106043 +Node: Peer filtering108447 +Node: BGP Peer Group108955 +Node: BGP Address Family109268 +Node: Autonomous System109422 +Node: AS Path Regular Expression110299 +Node: Display BGP Routes by AS Path111546 +Node: AS Path Access List111986 +Node: Using AS Path in Route Map112453 +Node: Private AS Numbers112734 +Node: BGP Communities Attribute112892 +Node: BGP Community Lists115353 +Node: Numbered BGP Community Lists118007 +Node: BGP Community in Route Map119594 +Node: Display BGP Routes by Community121537 +Node: Using BGP Communities Attribute122706 +Node: BGP Extended Communities Attribute126274 +Node: BGP Extended Community Lists128046 +Node: BGP Extended Communities in Route Map129921 +Node: Displaying BGP routes130380 +Node: Show IP BGP130617 +Node: More Show IP BGP131317 +Node: Capability Negotiation132468 +Node: Route Reflector135940 +Node: Route Server136219 +Node: Multiple instance137285 +Node: BGP instance and view139130 +Node: Routing policy140510 +Node: Viewing the view141278 +Node: How to set up a 6-Bone connection141563 +Node: Dump BGP packets and table142935 +Node: BGP Configuration Examples143517 +Node: Configuring Quagga as a Route Server152468 +Node: Description of the Route Server model153429 +Ref: fig:normal-processing155006 +Ref: fig:full-mesh155156 +Ref: fig:route-server155252 +Ref: filter-delegation155666 +Ref: Route Server tasks156850 +Ref: Route-server path filter process157221 +Ref: fig:rs-processing159535 +Node: Commands for configuring a Route Server159688 +Node: Example of Route Server Configuration162715 +Node: Configuration of the BGP routers without Route Server163636 +Node: Configuration of the BGP routers with Route Server166519 +Node: Configuration of the Route Server itself167820 +Node: Further considerations about Import and Export route-maps172819 +Node: VTY shell175863 +Node: VTY shell username176532 +Node: VTY shell integrated configuration177164 +Node: Filtering178612 +Node: IP Access List178965 +Node: IP Prefix List179351 +Node: ip prefix-list description182370 +Node: ip prefix-list sequential number control182897 +Node: Showing ip prefix-list183439 +Node: Clear counter of ip prefix-list184547 +Node: Route Map184986 +Node: Route Map Command188431 +Node: Route Map Match Command188740 +Node: Route Map Set Command189364 +Node: Route Map Call Command190272 +Node: Route Map Exit Action Command190602 +Node: Route Map Examples191084 +Node: IPv6 Support191596 +Node: Router Advertisement192168 +Node: Kernel Interface197784 +Node: SNMP Support199741 +Node: Getting and installing an SNMP agent200340 +Node: SMUX configuration200913 +Node: MIB and command reference203049 +Node: Handling SNMP Traps204464 +Node: Zebra Protocol210543 +Node: Packet Binary Dump Format212457 +Node: Command Index224067 +Node: VTY Key Index282728 End Tag Table |