| Age | Commit message (Collapse) | Author |
|---|
|
|
|
This code is only used one place and can be made local.
Gcc is smart enough to inline local functions if it wants to.
The function also has a big chunk of compatiablity code that
is no longer used; since quagga is now in a version control system
the source does not need to be used as a historical reference.
|
|
The following syntax forms were not historically supported
by Quagga, although IOS accepted them w/o a problem:
no ip ospf cost <1-65535>
no ospf cost <1-65535>
no ip ospf cost <1-65535> A.B.C.D
no ospf cost <1-65535> A.B.C.D
From now on Quagga also supports these variants.
|
|
* ospf_ism.c (ospf_dr_eligible_routers) should test for priority > 0 instead
of != 0 as ospf_nbr_new () initially sets prio to -1
|
|
* ospf_zebra.c: (ospf_distribute_check_connected) check to make filter out
routes matching connected routes was matching against OSPF networks, which
can be far more general than the actual connected interfaces. Fix.
|
|
* */*main.c: (main) Current versions of Gcc warn if the return value for
daemon() is not checked. So add a simple test and exit on failure.
|
|
Doing redistribute delete with full BGP table was taking
30 minutes, this drops it down to less than a second.
* ospf_lsa.c: (ospf_lsa_maxage) When flushing lots of entries the
performance is terrible because it looks up each LSA entry through
ospf_lsa_maxage_exist before deleting causing O(N^2) performance. Use a
new OSPF_LSA_MAXAGE flag instead of scan - and maintain it.
(ospf_lsa_maxage_exist) removed
(ospf_lsa_maxage_delete) maintain OSPF_LSA_MAXAGE flag
|
|
In some cases ospfd does not recalc the route table. This
happens when ospfd receives an old LSA which will trigger
recalc but the this recalc will fail because all interfaces
isn't up yet. Next LSA that is originated matches the old one
so no recalc will be performed. This problem has been observed
when there are only 2 ppp I/Fs in an area, both go down at the
same time, then they come up again with a few seconds apart.
* ospf_lsa.c: (ospf_{router,network}_lsa_install) avoid a needless scheduling
of SPF.
(ospf_lsa_different) fix bug in LSA comparison that would lead to the
described failure to schedule SPF.
|
|
* ospf_packet.c: make this message conditional on 'debug ospf event', as it
be easily triggered with, e.g., multiple subnets sharing same physical
network. E.g, see bug #532.
|
|
* ospf_lsa.c: (link_info_set) Use %zd for size_t - C99 is old enough now.
Lots of similar warnings all over the code.
(ospf_lsa_translated_nssa_compare) Unused func - delete.
|
|
* ospf_{spf,lsa}.c: remove out of date comment; add comment on some
non-obvious code; Make note of a possible scaling problem.
|
|
* global: In struct ospf_path, change struct ospf_interface *oi to int
ifindex. It is unsafe to reference *oi as an ospf interface can be
deleted under your feet. Use a weak reference instead.
|
|
* ospf_spf.c: (ospf_get_next_link) One must check the vertex type, Router or
Network, to select type link to match against. Link type 1 has neighbour
router ID in link_id and link type 2 has IP address of DR. Since router
id may have same value as an existing IP address one risks matching a
router ID against a DR.
|
|
This function will return the interface for the first matching
remote address for PtP i/f's. That won't work for multiple
unnumbered i/f's as these may all have the same address.
Pass in the struct interface pointer, ifp, to find the
correct set of oi's to search in. This also reduces the
size of the search list, making it faster.
* ospfd/ospf_interface.c: Add struct interface * param to
ospf_if_lookup_recv_if() to select the right list to search in.
* ospfd/ospf_interface.h: ditto.
* ospfd/ospf_packet.c: Pass new ifp argument to ospf_if_lookup_recv_if()
|
|
Makes it possible to run OSPF on multiple PtP interfaces
with the same remote address.
* ospfd/ospf_interface.c: Export ospf_if_table_lookup().
* ospfd/ospf_interface.h: ditto.
* ospfd/ospfd.c: (ospf_network_run_interface) Use ospf_if_table_lookup() to
determine whether OSPF is already configured for a subnet and interface.
|
|
*/*: ifp->flags is 64 bit unsigned which can not be handled by %l on 32
bit architectures - requires %ll and the appropriate cast.
|
|
Should a self originated Network/Router LSA with higher
LS seq. nr. be received we should flood and install it in
the LSDB but we cannot use it for our internal calculations
as it is stale.
Reorginate an new LSA to replace the stale one as soon
as possible.
|
|
ospf_path_lookup(), ospf_route_match_same() and
ospf_ase_route_match_same() needs to
compare if the interface matches too.
|
|
A few route_unlock_node() calls was missing.
|
|
ospf_lsa_install() will calculate LSA checksum so no
need to do it before calling ospf_lsa_install().
Set the OSPF_LSA_SELF_CHECKED flag on own LSA's to
save ospf_lsa_is_self_originated() some work.
Do not memset() memory that is about to overwritten
with memcpy().
|
|
|
|
|
|
|
|
This piece of code causes all Quagga routers on a broadcast link to
send a HELLO packet simultaneously if they see a new neighbor. It also
resets the HELLO timer, so all the quagga routers will continue to
send HELLO packets simultaneously in the future. This is not good
(especially on networks with a lot of Quagga routers connected), and
is explicitly discouraged by the OSPF standard, RFC 2328 (chapter
4.4.Timers).
I suggest to remove the code snippet, it does not provide much benefit
anyway.
|
|
Should probably have AC_TYPE_UINT16_T in configure.ac to make it really
clean... and a fresh import of gnulib, the existing copy of gnulib seems to
be manually put some stuff in zebra.h. I'm leaving that alone for now,
since a fresh import will probably clean up a lot of cruft and it would be a
duplicated effort to fix some things now.
The FreeBSD port 0.99.11_1 files/patch-ospfd-ospfd.h can probably go away
after this is applied.
|
|
* */*main.c: Seems that the actual code was removed previously, but the
argument processing code remained.
|
|
|
|
This may fix vyatta BUG 3096. The reference count for OSPF route table was
never completely freed on deleting all neighbors.
|
|
The cmd_nodes used to configure vty, can mostly be static so
(basic data hiding 101).
|
|
Use Ansi-C prototypes rather than old K&R method of declaring
function without arguments
|
|
Simple conversion of XMALLOC/memset to XCALLOC
|
|
Compiled on 32-bit and 64-bit linux gcc 4.1.2 platforms.
No run-time testing on 32-bit and limited run-time testing on 64-bit.
|
|
"no ospf abr-type standard" was broken
|
|
ospf cost <1-65535> A.B.C.D
no ospf cost <1-65535>
|
|
* ospfd/ospfd.c: (opsf_if_update) Check if ospf_lookup() returns NULL.
Fixes bug introduced with recent ospf_network_run changes in
a49eb30a, where SEGV will happen if not the "router ospf" command has
been executed before the first interfaces are reported by zebra.
Signed-off-by: Paul Jakma <paul@quagga.net>
|
|
* ospf_packet.c: Apply passive check and drop for all packages
and not just Hellos.
Signed-off-by: Paul Jakma <paul@quagga.net>
|
|
* ospf_spf.c: (ospf_spf_process_stubs) Track whether
parent router vertex is the root, so that the host-route
suppression logic need only be activated for such vertices.
Move the actual logic to ospf_intra_add_stub.
* ospf_route.c: (ospf_intra_add_stub) Main test of link moved
here, notionally more appropriate.
|
|
|
|
|
|
Add an struct interface paramenter and adjust the affected
code accordingly.
The old code was a mess looping over all interfaces several times
when one interface was added/changed.
* ospfd/ospfd.h: Add struct interface parameter to ospf_if_update()
* ospfd/ospf_zebra.c: Add ifp arg to ospf_if_update() calls.
(ospf_interface_address_delete) delete ospf_if_update() call,
redundant as function calls ospf_if_free() itself.
* ospfd/ospfd.c: (ospf_network_unset) handle deconfiguration here,
rather than ospf_if_update.
(ospf_network_run_interface) ospf_network_run, for
any given interface.
(ospf_network_run) move guts to previous, and use it.
(ospf_if_update) Adjust to take struct interface as argument, as
all callers have a specific ifp in mind.
Iterate over ifp's connected list and call ospf_network_run_interface
instead of ospf_network_run, turning this path into O(nm) rather
than O(n^2).
Adjust all code dealing with opsf_if_update and ospf_network_run to
pass the new struct interface * arg.
(some minor modifications and bug-additions by Paul Jakma).
Signed-off-by: Paul Jakma <paul@quagga.net>
|
|
'remotes/jocke/snmp_crosscompile'
|
|
Update ospf_db_desc_send(), ospf_ls_upd_queue_send() and ospf_ls_req_send()
to always use OSPF_ALLSPFROUTERS for PtP links.
See RFC 2328, chap 8.1 for details:
"The IP destination address for the packet is selected as
follows. On physical point-to-point networks, the IP
destination is always set to the address AllSPFRouters."
Without this, it won't be possible to establish adjacencies on
multiple unnumbered links to the same router.
ChangeLog:
2008-07-25 Joakim Tjernlund <Joakim.Tjernlund@transmode.se>
* ospfd/ospf_packet.c: Set destination for PtP links to
OSPF_ALLSPFROUTERS.
|
|
PtP links with /32 masks adds host routes to the remote host,
see RFC 2328, 12.4.1.1, Option 1.
Make sure that such routes are ignored
|
|
--without-crypto
Autoconfig work by me, the rest was done by
"Kirill K. Smirnov" <lich@math.spbu.ru>
|
|
Dont use vty->index in show_ip_ospf_neighbor_all_cmd(),
It is invalid, use ospf_lookup() instead.
|
|
|
|
|
|
2008-08-15 Paul Jakma <paul.jakma@sun.com>
* */*: Fix various problems flagged by Sun Studio compiler.
- '<qualifier> <storage>' obsolescent in declarations
- empty statements (';' after ALIAS definitions)
- implicit declarations (e.g printstack in lib/log.c)
- "\%" in printf string instead of "%%"
- loops that return on the first iteration (legitimately, but
compiler can't really know), e.g. bgp_routemap.c
- internal declarations which mask prototypes.
|
|
2008-08-14 Stephen Hemminger <stephen.hemminger@vyatta.com>
* lib/log.{c,h}: struct message argument should point to const
* */*.c: adjust to suit,
Signed-off-by: Paul Jakma <paul@quagga.net>
|
|
2008-08-13 Daniel Ng <daniel_ng11@lycos.com>
* ospf_nsm.c: (nsm_change_state) Refresh default route on
state change - a hack, but it works.
Signed-off-by: Paul Jakma <paul@quagga.net>
|
