summaryrefslogtreecommitdiff
path: root/zebra
AgeCommit message (Collapse)Author
2011-08-28zebra: add missing includesDenis Ovsienko
2010-08-19Zebra zserv: bogus conditionalStephen Hemminger
This looks like a bug in original code from misunderstanding of C rules of evaluation.
2010-05-05zebra: fix infinite loop when deleting an interfaceRoman Hoog Antink
When deleting a VLAN interface after flushing its addresses, zebra uses 100% CPU time and freezes. * interface.c: The while loop in line 407 that should clean up connected routes never hits one of the 2 lines "last = node;" and thus loops forever. Signed-off-by: Roman Hoog Antink <rha@open.ch>
2009-12-21zebra: change router-id selection algoStephen Hemminger
The router-id table looks like is supposed to be sorted in current quagga code, but the nodes are not added with the sorting function. The sorting function is host byte order dependent. The values need to converted before comparison. Fixing this causes Zebra to choose the largest IP address as router-id, rather than the last address. This probably will surprise some users. The other option would be to just remove the comparison function and keep the existing LIFO behavior. Lastly, simple subtraction works well for comparing. * zebra/router-id.c * router_id_add_address(): employ listnode_add_sort() * router_id_cmp(): employ ntohl(), then compare integers
2009-12-10zebra: deal with irdp compile warningsStephen Hemminger
* zebra/irdp.h * irdp_send_thread(): move prototype to common header file * irdp_advert_off(): idem * process_solicit(): idem * irdp_read_raw(): idem * send_packet(): idem * zebra/irdp_interface.c * inet_2a(): move function to where it is used * in_cksum(): lib/checksum.h already provides prototype * irdp_send_thread(): prototype moved away * inet_2a(): idem * irdp_advert_off(): idem * b1, b2, b3, b4: get rid of global buffers for inet_2a() * if_group(): add local buffer for inet_2a() * if_add_group(): idem * if_drop_group(): idem * irdp_config_write(): idem * Adv_new(): make static * zebra/irdp_main.c * irdp_read_raw(): prototype moved away * send_packet(): idem * in_cksum(): lib/checksum.h already provides prototype * inet_2a(): function moved to irdp_interface.c * zebra/irdp_packet.c * b1, b2, b3, b4: get rid of global buffers for inet_2a() * in_cksum(): lib/checksum.h already provides prototype * process_solicit(): prototype moved away * irdp_read_raw(): fix uninitialized variable
2009-12-09zebra: cleanup RIB meta queue codeStephen Hemminger
* zebra/zebra_rib.c * rib_queue_add(): indent comments and simplify debug code * rib_queue_init(): remove unneeded assert() calls and extra return statements
2009-12-08zebra: fix more warnings in rtadvStephen Hemminger
* zebra/rtadv.c * rtadv_free(): remove unused function * rtadv_recv_packet(): break up cast/dereference to avoid compiler type pun warning * rtadv_read(): initialize ifindex, because compiler can't figure out that it is okay
2009-12-08Merge branch 'master' of ssh://code.quagga.net/var/lib/git/quaggaDenis Ovsienko
2009-12-08zebra: fix more compiler warningsStephen Hemminger
* zebra/zebra_rib.c * nexthop_active_update(): make local int vars unsigned * nexthop_active_check(): return unsigned for consistency * rib_dump(): cast time in printf format * vrf_free(): remove unused function * vrf_lookup_by_name(): idem * rib_if_up(): idem * rib_if_down(): idem
2009-12-08zebra: remove unused function to fix warningStephen Hemminger
* zebra/interface.c * if_supported_family(): sayonara
2009-12-03zebra: handle RTF_CLONING removal from FreeBSD 8.0David Ward
The RTF_CLONING flag has been removed in FreeBSD 8.0 with arp-v2 (see http://svn.freebsd.org/viewvc/base/stable/8/UPDATING?view=markup), since it no longer has any meaning. This patch checks if RTF_CLONING exists before using it.
2009-12-03zebra: fix argument reference in strncpy() call for BSDheasley
2009-12-03zebra: fix RIB debug message for IPv6David Ward
Apply changes from commit f304cb48f0d7d0ff8f36e7aca8293141a9fa9e60 to rib_queue_add. Also includes spelling fixes.
2009-12-03zebra: make declaration const in rtm_flag_dump()Tom Goff
* kernel_socket.c: (rtm_flag_dump) Use a const message pointer to be in sync with commit ce0db9cb11c0bc2e7f89a7d042e50afa495556b4.
2009-09-01zebra: Fix router advertisements for non-Ethernet link layer addressesDavid Ward
* rtadv.c: round up when calculating the link-layer address option length; add padding to the option if needed to end on an octet boundary
2009-08-28zebra: Add an example config file for testzebraPaul Jakma
* testrib.conf: Example config file for testzebra
2009-08-28zebra: test_main.c should be a bit more helpful about its usagePaul Jakma
* test_main.c: If required arguments are missing, say that.
2009-08-13all: check return value from daemon() callStephen Hemminger
* */*main.c: (main) Current versions of Gcc warn if the return value for daemon() is not checked. So add a simple test and exit on failure.
2009-07-28[zebra] Fix crash in test_zebraPaul Jakma
* kernel_null.c: we're pretending to add an address, so set IFC_REAL. If this isn't done, calling into the 'got address from kernel' half of zebra will implicitly-withdraw the ifc, which could cause a crash in test_zebra.c.
2009-07-24[zebra] do not touch socket before pidfile lockingDenis Ovsienko
Move zserv socket creation code into zebra_zserv_socket_init() and call it only after pidfile lock has been acquired exclusively. This keeps subsequent zebra daemons from deleting the working socket of an already running process (bug #403).
2009-07-21[zebra] Silence noisy process_subqChris Caputo
zebra_rib.c: process_subq(): #ifdef out debug code.
2009-06-24zebra: Static route does not reach kernel.Joakim Tjernlund
A static route like below: ip route 172.16.1.0/30 192.168.101.162 11 does not move properly to a new interface when the interface used goes down. Zebra reports that it have moved but kernel isn't informed so the route is lost. * zebra_rib.c: (nexthop_active_update) if ifindex has changed, then the route should be considered to have changed. Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund@transmode.se>
2009-06-23[zebra] linux policy routing support with ipv6Mathieu Goessens
Quagga support linux policy routing (ip route ... table $X) with zebra.conf table $X option. It works fine on ipv4. On ipv6 the parameter is ignored (table 0 is used). * zebra/...: Pass appropriate table arg to rib_{add,delete}_ipv6
2009-06-23RFC 4191 Default Router Preference support for router advertisementsChris Caputo
Adds "ipv6 nd router-preference (high|medium|low)" and "no ipv6 nd router-preference" interface commands. Files modified: doc/ipv6.texi zebra/interface.c zebra/interface.h zebra/rtadv.c zebra/rtadv.h Signed-off-by: Chris Caputo <ccaputo@alt.net>
2009-06-19[cleanup] convert bzero() deprecated by POSIX to memset()Jeremy Jackson
autoscan 2.62 complains about bzero(), so a good fix nowadays is to just replace it.
2009-06-18[daemons/cleanup] Remove disabled log_mode argument support.Jeremy Jackson
* */*main.c: Seems that the actual code was removed previously, but the argument processing code remained.
2009-06-18[zebra/cleanup] make message table read onlyStephen Hemminger
2009-06-18[zebra] Remove unused structure elementStephen Hemminger
2009-06-18[zebra] Force rib_update when connected route deletedStephen Hemminger
2009-06-18[cleanup] Use correct buffer size for inet_ntop()Stephen Hemminger
Don't need big buffer 1024 to hold IPV4 (INET_ADDRSTRLEN) or IPv6 (INET6_ADDRSTRLEN) message.
2009-06-18[zebra] Only announce connected routes if link is detectedStephen Hemminger
Need to check both IFF_UP and IFF_RUNNING if link-detect is enabled, before announcing routes.
2009-06-18[zebra] MTU is unsignedStephen Hemminger
The MTU data in the netlink message is always unsigned 32 bits. Don't use integer.
2009-06-18[zebra] remove incorrect debug messageStephen Hemminger
2009-06-18[zebra] Cleanup meta-queue codeStephen Hemminger
Do some cleanup work on recently added meta-queue code: * use table rather than switch * indent with quagga standard indentation * since meta_queue_new is only used at initialization allocation failure should be fatal.
2009-06-18[zebra] netlink interface minor cleanupStephen Hemminger
Add more prototypes and make some functions static
2009-06-18[zebra] Fix vyatta bug 2814: Add "show ip route summary" command.Stig Thormodsrud
2009-06-12[cleanup] Make command nodes staticStephen Hemminger
The cmd_nodes used to configure vty, can mostly be static so (basic data hiding 101).
2009-06-12[cleanup] functions taking no args should be declared with void argsStephen Hemminger
Use Ansi-C prototypes rather than old K&R method of declaring function without arguments
2009-06-12[cleanup] Convert XMALLOC/memset to XCALLOCStephen Hemminger
Simple conversion of XMALLOC/memset to XCALLOC
2009-06-02[snmp] Compiler warning fixes for when "--enable-snmp" is configured.Chris Caputo
Compiled on 32-bit and 64-bit linux gcc 4.1.2 platforms. No run-time testing on 32-bit and limited run-time testing on 64-bit.
2008-09-01Merge commit 'remotes/jocke/ospf_neighbour'; commit ↵Paul Jakma
'remotes/jocke/snmp_crosscompile'
2008-08-26testPaul Jakma
2008-08-25Make --enable-snmp cross compile and make libcrypto optional with ↵Joakim Tjernlund
--without-crypto Autoconfig work by me, the rest was done by "Kirill K. Smirnov" <lich@math.spbu.ru>
2008-08-22[administrivia] Update gitignore filesPaul Jakma
- Add more stuff, archive libraries, etc..
2008-08-22[administrivia] Git should ignore backup files and .loT filesPaul Jakma
2008-08-22[trivia] Remove ChangeLog files, as this data is now maintained in SCMPaul Jakma
2008-08-22[zebra] trivial: fix spelling mistakeStephen Hemminger
2008-08-22[zebra] trivia: static qualifiers for metaqStephen Hemminger
2008-08-17 Stephen Hemminger <stephen.hemminger@vyatta.com> * zebra_rib.c: (process_subq) mark static (rib_meta_queue_add) ditto (meta_queue_new) ditt Signed-off-by: Paul Jakma <paul@quagga.net>
2008-08-22[zebra] make some data localStephen Hemminger
2008-06-17 Stephen Hemminger <stephen.hemminger@vyatta.com> * zebra_rib.c: static qualifier on local data Signed-off-by: Paul Jakma <paul@quagga.net>
2008-08-22[zebra] ignore dead routes in RIB updateStephen Hemminger
2008-08-17 Stephen Hemminger <stephen.hemminger@vyatta.com> * zebra_rib.c: When doing a RIB update, routes in process of removal should be ignored. This fixes bugs where a route is removed but a recursive route is not changed. Signed-off-by: Paul Jakma <paul@quagga.net>