diff options
| -rw-r--r-- | Sprinter/Configuration.h | 8 |
1 files changed, 4 insertions, 4 deletions
diff --git a/Sprinter/Configuration.h b/Sprinter/Configuration.h index 00eaf55..53ab2e5 100644 --- a/Sprinter/Configuration.h +++ b/Sprinter/Configuration.h @@ -33,7 +33,7 @@ float axis_steps_per_unit[] = {80, 80, 3200/1.25,700}; //float axis_steps_per_unit[] = {104.987, 104.987, 4545.4544, 1487}; //// Endstop Settings -#define ENDSTOPPULLUPS 1 // Comment this out (using // at the start of the line) to disable the endstop pullup resistors +#define ENDSTOPPULLUPS // Comment this out (using // at the start of the line) to disable the endstop pullup resistors // The pullups are needed if you directly connect a mechanical endswitch between the signal and ground pins. const bool ENDSTOPS_INVERTING = false; //set to true to invert the logic of the endstops //If your axes are only moving in one direction, make sure the endstops are connected properly. @@ -43,7 +43,7 @@ const bool ENDSTOPS_INVERTING = false; //set to true to invert the logic of the #define BAUDRATE 115200 // Comment out (using // at the start of the line) to disable SD support: -#define SDSUPPORT 1 +#define SDSUPPORT //// ADVANCED SETTINGS - to tweak parameters @@ -95,7 +95,7 @@ bool axis_relative_modes[] = {false, false, false, false}; //#define STEP_DELAY_RATIO 0.25 // Comment this to disable ramp acceleration -#define RAMP_ACCELERATION 1 +#define RAMP_ACCELERATION //// Acceleration settings #ifdef RAMP_ACCELERATION @@ -115,7 +115,7 @@ char uuid[] = "00000000-0000-0000-0000-000000000000"; //// PID settings: // Uncomment the following line to enable PID support. This is untested and could be disastrous. Be careful. -//#define PIDTEMP 1 +//#define PIDTEMP #ifdef PIDTEMP #define PID_MAX 255 // limits current to nozzle #define PID_INTEGRAL_DRIVE_MAX 220 |