diff options
| -rw-r--r-- | Tonokip_Firmware/configuration.h | 27 |
1 files changed, 17 insertions, 10 deletions
diff --git a/Tonokip_Firmware/configuration.h b/Tonokip_Firmware/configuration.h index 268e05c..5a5551f 100644 --- a/Tonokip_Firmware/configuration.h +++ b/Tonokip_Firmware/configuration.h @@ -1,9 +1,10 @@ + #ifndef PARAMETERS_H #define PARAMETERS_H // NO RS485/EXTRUDER CONTROLLER SUPPORT // PLEASE VERIFY PIN ASSIGNMENTS FOR YOUR CONFIGURATION!!!!!!! -#define MOTHERBOARD 4 // ATMEGA168 0, SANGUINO 1, MOTHERBOARD = 2, MEGA 3, ATMEGA328 4 +#define MOTHERBOARD 3 // ATMEGA168 0, SANGUINO 1, MOTHERBOARD = 2, MEGA 3, ATMEGA328 4 // THERMOCOUPLE SUPPORT UNTESTED... USE WITH CAUTION!!!! const bool USE_THERMISTOR = true; //Set to false if using thermocouple @@ -14,12 +15,18 @@ const bool USE_THERMISTOR = true; //Set to false if using thermocouple // units are in millimeters or whatever length unit you prefer: inches,football-fields,parsecs etc //Calibration variables -float x_steps_per_unit = 10.047; -float y_steps_per_unit = 10.047; -float z_steps_per_unit = 833.398; -float e_steps_per_unit = 0.706; +float x_steps_per_unit = 80.376; +float y_steps_per_unit = 80.376; +float z_steps_per_unit = 6667.184; +float e_steps_per_unit = 16; float max_feedrate = 3000; +//float x_steps_per_unit = 10.047; +//float y_steps_per_unit = 10.047; +//float z_steps_per_unit = 833.398; +//float e_steps_per_unit = 0.706; +//float max_feedrate = 3000; + //For Inverting Stepper Enable Pins (Active Low) use 0, Non Inverting (Active High) use 1 const bool X_ENABLE_ON = 0; const bool Y_ENABLE_ON = 0; @@ -34,8 +41,8 @@ const bool DISABLE_E = false; const bool INVERT_X_DIR = false; const bool INVERT_Y_DIR = false; -const bool INVERT_Z_DIR = false; -const bool INVERT_E_DIR = false; +const bool INVERT_Z_DIR = true; +const bool INVERT_E_DIR = true; //Endstop Settings const bool ENDSTOPS_INVERTING = true; @@ -43,8 +50,8 @@ const bool min_software_endstops = false; //If true, axis won't move to coordina const bool max_software_endstops = true; //If true, axis won't move to coordinates greater than the defined lengths below. const int X_MAX_LENGTH = 200; const int Y_MAX_LENGTH = 200; -const int Z_MAX_LENGTH = 120; +const int Z_MAX_LENGTH = 70; -#define BAUDRATE 19200 +#define BAUDRATE 115200 -#endif
+#endif
\ No newline at end of file |