diff options
Diffstat (limited to 'Sprinter')
| -rw-r--r-- | Sprinter/Configuration.h | 5 |
1 files changed, 3 insertions, 2 deletions
diff --git a/Sprinter/Configuration.h b/Sprinter/Configuration.h index 354e59d..f0001da 100644 --- a/Sprinter/Configuration.h +++ b/Sprinter/Configuration.h @@ -31,10 +31,11 @@ float axis_steps_per_unit[] = {80, 80, 3200/1.25,700}; //// Endstop Settings #define ENDSTOPPULLUPS 1 // Comment this out (using // at the start of the line) to disable the endstop pullup resistors // The pullups are needed if you directly connect a mechanical endswitch between the signal and ground pins. -const bool ENDSTOPS_INVERTING = false; //set to true to invert the logic of the endstops //If your axes are only moving in one direction, make sure the endstops are connected properly. //If your axes move in one direction ONLY when the endstops are triggered, set ENDSTOPS_INVERTING to true here - +cost bool X_ENDSTOP_INVERT = false;//set to true to invert the logic of the endstops +cost bool Y_ENDSTOP_INVERT = false;//set to true to invert the logic of the endstops +cost bool Z_ENDSTOP_INVERT = false;//set to true to invert the logic of the endstops // This determines the communication speed of the printer #define BAUDRATE 115200 |