| Age | Commit message (Collapse) | Author |
|---|
|
Fix so the FAN pin is set as output and fixed fan off case for PWM pins
|
|
|
|
|
|
|
|
|
|
|
|
Removed all unnecessary config option values to avoid confusion
|
|
think that setting them to 0 disabled the feature, while it has to be commented instead)
|
|
Tiny change to confusing config option
|
|
feature, so that's just confusing.
|
|
Add EPCOS 100k thermistor table.
|
|
|
|
Add EPCOS thermistor table to configuration.
|
|
|
|
|
|
|
|
ParCan Thermistor table added
|
|
ATmega1284P support
|
|
use the fan pin to power the hot end heater on the crappy techzone monotronics
|
|
heater. meaning.. this setup will not support a bed heat control ..for now... Time will show if I can get the Tip management A/D converter to work... or.. should i get it to work at all???
|
|
Limited Gen 3 with 644P support - support gen3 with gen3+ board and the techzone monolithic electronics with thermistor only
|
|
|
|
|
|
|
|
|
|
|
|
MakerGear Hybrid Prusa Mendel steps per unit values
|
|
|
|
|
|
|
|
without acceleration
|
|
added uuid identification support
|
|
|
|
|
|
Added Ramps 1.3 Pin assignments for E1
|
|
This is my first commit…Please don't hurt me if i screw up!
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fix homing to max endstops
|
|
always reset to 0.
|
|
|
|
Respect HEATER_USES_* when initializing temperature smoothing
|
|
|
|
This reverts commit b31c7a837ff5baff89043f3c06b1b2191ed9f79d.
|
|
|
