diff options
Diffstat (limited to 'Sprinter/Configuration.h')
| -rw-r--r-- | Sprinter/Configuration.h | 9 |
1 files changed, 5 insertions, 4 deletions
diff --git a/Sprinter/Configuration.h b/Sprinter/Configuration.h index f0001da..2594593 100644 --- a/Sprinter/Configuration.h +++ b/Sprinter/Configuration.h @@ -32,10 +32,11 @@ float axis_steps_per_unit[] = {80, 80, 3200/1.25,700}; #define ENDSTOPPULLUPS 1 // Comment this out (using // at the start of the line) to disable the endstop pullup resistors // The pullups are needed if you directly connect a mechanical endswitch between the signal and ground pins. //If your axes are only moving in one direction, make sure the endstops are connected properly. -//If your axes move in one direction ONLY when the endstops are triggered, set ENDSTOPS_INVERTING to true here -cost bool X_ENDSTOP_INVERT = false;//set to true to invert the logic of the endstops -cost bool Y_ENDSTOP_INVERT = false;//set to true to invert the logic of the endstops -cost bool Z_ENDSTOP_INVERT = false;//set to true to invert the logic of the endstops +//If your axes move in one direction ONLY when the endstops are triggered, set [XYZ]_ENDSTOP_INVERT to true here: +const bool X_ENDSTOP_INVERT = false; +const bool Y_ENDSTOP_INVERT = false; +const bool Z_ENDSTOP_INVERT = false; + // This determines the communication speed of the printer #define BAUDRATE 115200 |