diff options
Diffstat (limited to 'Sprinter/Configuration.h')
-rw-r--r-- | Sprinter/Configuration.h | 8 |
1 files changed, 7 insertions, 1 deletions
diff --git a/Sprinter/Configuration.h b/Sprinter/Configuration.h index 59c332f..354e59d 100644 --- a/Sprinter/Configuration.h +++ b/Sprinter/Configuration.h @@ -113,13 +113,15 @@ char uuid[] = "00000000-0000-0000-0000-000000000000"; // Uncomment the following line to enable PID support. This is untested and could be disastrous. Be careful. //#define PIDTEMP 1 #ifdef PIDTEMP -#define PID_MAX 255 // limits current to nozzle #define PID_INTEGRAL_DRIVE_MAX 220 #define PID_PGAIN 180 //100 is 1.0 #define PID_IGAIN 2 //100 is 1.0 #define PID_DGAIN 100 //100 is 1.0 #endif +// Change this value (range 1-255) to limit the current to the nozzle +#define HEATER_CURRENT 255 + // How often should the heater check for new temp readings, in milliseconds #define HEATER_CHECK_INTERVAL 500 #define BED_CHECK_INTERVAL 5000 @@ -143,6 +145,10 @@ char uuid[] = "00000000-0000-0000-0000-000000000000"; // If the temperature has not increased at the end of that period, the target temperature is set to zero. It can be reset with another M104/M109 //#define WATCHPERIOD 5000 //5 seconds +// Actual temperature must be close to target for this long before M109 returns success +//#define TEMP_RESIDENCY_TIME 20 // (seconds) +//#define TEMP_HYSTERESIS 5 // (C°) range of +/- temperatures considered "close" to the target one + //// The minimal temperature defines the temperature below which the heater will not be enabled #define MINTEMP 5 |