diff options
Diffstat (limited to 'Sprinter/Configuration.h')
| -rw-r--r-- | Sprinter/Configuration.h | 12 |
1 files changed, 11 insertions, 1 deletions
diff --git a/Sprinter/Configuration.h b/Sprinter/Configuration.h index df52a08..be42e0b 100644 --- a/Sprinter/Configuration.h +++ b/Sprinter/Configuration.h @@ -50,9 +50,13 @@ const bool Z_ENDSTOP_INVERT = false; // Comment out (using // at the start of the line) to disable SD support: #define SDSUPPORT - //// ADVANCED SETTINGS - to tweak parameters +#ifdef SDSUPPORT + //Fast transfer chunk size (> 1024 is unstable, change at your own risk). + #define SD_FAST_XFER_CHUNK_SIZE 1024 +#endif + #include "thermistortables.h" // For Inverting Stepper Enable Pins (Active Low) use 0, Non Inverting (Active High) use 1 @@ -99,6 +103,12 @@ bool axis_relative_modes[] = {false, false, false, false}; // If you enable this, make sure STEP_DELAY_MICROS is disabled. (except for Gen6: both need to be enabled.) //#define STEP_DELAY_RATIO 0.25 +///Oscillation reduction. Forces x,y,or z axis to be stationary for ## ms before allowing axis to switch direcitons. Alternative method to prevent skipping steps. Uncomment the line below to activate. +//#define RAPID_OSCILLATION_REDUCTION +#ifdef RAPID_OSCILLATION_REDUCTION +long min_time_before_dir_change = 30; //milliseconds +#endif + // Comment this to disable ramp acceleration #define RAMP_ACCELERATION |