rewrite

1 files changed, 45 insertions, 0 deletions

diff --git a/Tonokip_Firmware/configuration.h b/Tonokip_Firmware/configuration.h
new file mode 100644
index 0000000..fec610b
--- /dev/null
+++ b/Tonokip_Firmware/configuration.h
@@ -0,0 +1,45 @@
+#ifndef PARAMETERS_H

+#define PARAMETERS_H

+

+// NO RS485/EXTRUDER CONTROLLER SUPPORT

+// PLEASE VERIFY PIN ASSIGNMENTS FOR YOUR CONFIGURATION!!!!!!!

+#define MOTHERBOARD 4 // ATMEGA168 0, SANGUINO 1, MOTHERBOARD = 2, MEGA 3, ATMEGA328 4

+

+// THERMOCOUPLE SUPPORT UNTESTED... USE WITH CAUTION!!!!

+const bool USE_THERMISTOR = true; //Set to false if using thermocouple

+

+// Calibration formulas

+// e_extruded_steps_per_mm = e_feedstock_steps_per_mm * (desired_extrusion_diameter^2 / feedstock_diameter^2)

+// new_axis_steps_per_mm = previous_axis_steps_per_mm * (test_distance_instructed/test_distance_traveled)

+// units are in millimeters or whatever length unit you prefer: inches,football-fields,parsecs etc

+

+//Calibration variables

+float x_steps_per_unit = 10.047;

+float y_steps_per_unit = 10.047;

+float z_steps_per_unit = 833.398;

+float e_steps_per_unit = 0.706;

+float max_feedrate = 3000;

+

+//For Inverting Stepper Enable Pins (Active Low) use 0, Non Inverting (Active High) use 1

+const bool X_ENABLE_ON = 0;

+const bool Y_ENABLE_ON = 0;

+const bool Z_ENABLE_ON = 0;

+const bool E_ENABLE_ON = 0;

+

+//Disables axis when it's not being used.

+const bool DISABLE_X = false;

+const bool DISABLE_Y = false;

+const bool DISABLE_Z = true;

+const bool DISABLE_E = false;

+

+//Endstop Settings

+const bool ENDSTOPS_INVERTING = true;

+const bool min_software_endstops = false; //If true, axis won't move to coordinates less than zero.

+const bool max_software_endstops = true;  //If true, axis won't move to coordinates greater than the defined lengths below.

+const int X_MAX_LENGTH = 200;

+const int Y_MAX_LENGTH = 200;

+const int Z_MAX_LENGTH = 120;

+

+#define BAUDRATE 19200

+

+#endif