diff options
Diffstat (limited to 'Tonokip_Firmware')
| -rw-r--r-- | Tonokip_Firmware/Tonokip_Firmware.pde | 23 |
1 files changed, 16 insertions, 7 deletions
diff --git a/Tonokip_Firmware/Tonokip_Firmware.pde b/Tonokip_Firmware/Tonokip_Firmware.pde index 1ca5239..f9ae699 100644 --- a/Tonokip_Firmware/Tonokip_Firmware.pde +++ b/Tonokip_Firmware/Tonokip_Firmware.pde @@ -28,7 +28,7 @@ // M82 - Set E codes absolute (default) // M83 - Set E codes relative while in Absolute Coordinates (G90) mode // M84 - Disable steppers until next move - +// M85 - Set inactivity shutdown timer with parameter S<seconds>. To disable set zero (default) //Stepper Movement Variables bool direction_x, direction_y, direction_z, direction_e; @@ -55,7 +55,9 @@ char *strchr_pointer; // just a pointer to find chars in the cmd string like X, int target_raw = 0; int current_raw; - +//Inactivity shutdown variables +unsigned long previous_millis_cmd=0; +unsigned long max_inactive_time = 0; void setup() { @@ -94,6 +96,9 @@ void loop() { get_command(); manage_heater(); + + //shutdown if not receiving any new commands + if( (millis()-previous_millis_cmd) > max_inactive_time ) if(max_inactive_time) kill(); } inline void get_command() @@ -278,10 +283,9 @@ inline void process_commands() if (code_seen('S')) target_raw = temp2analog(code_value()); break; case 105: // M105 - Serial.print("T:"); - Serial.println( analog2temp(analogRead(TEMP_0_PIN)) ); - if(code_seen('N')) Serial.println("ok"); // If M105 is sent from generated gcode, then it needs a response. - return; //If RepSnapper sends the M105 then DON'T respond "ok". + Serial.print("T:"); + Serial.println( analog2temp(analogRead(TEMP_0_PIN)) ); + if(!code_seen('N')) return; // If M105 is sent from generated gcode, then it needs a response. break; case 109: // M109 - Wait for heater to reach target. if (code_seen('S')) target_raw = temp2analog(code_value()); @@ -314,6 +318,10 @@ inline void process_commands() disable_z(); disable_e(); break; + case 85: // M85 + code_seen('S'); + max_inactive_time = code_value()*1000; + break; } } @@ -332,6 +340,7 @@ inline void FlushSerialRequestResend() inline void ClearToSend() { + previous_millis_cmd = millis(); Serial.println("ok"); } @@ -565,7 +574,7 @@ inline void kill() while(1) { - Serial.print("Fatal Exception Shutdown, Last Line: "); + Serial.print("Shutdown, Last Line: "); Serial.println(gcode_LastN); delay(5000); // 5 Second delay } |